Fini AB1PAK Manuel d'utilisation et d'entretien télécharger pdf (Page 15)

WARNING:

When servicing, use only identical replacement parts.

Use of any other parts may create a hazard or cause

product damage.

WARNING:

Always wear safety goggles or safety glasses with side

shields during power tool operation or when blowing

dust. If operation is dusty, also wear a dust mask.

WARNING:

Always release all pressure, disconnect from power

supply, and allow unit to cool to the touch before

cleaning or making repairs on the air compressor.

MAINTENANCE

GENERAL MAINTENANCE

Humidity in the air causes condensation to form in the air

tank. This condensation should be drained daily and/or

every hour, using the instructions found in Draining the

Tank.

The safety valve automatically releases air if the air

receiver pressure exceeds the preset maximum. Check

the safety valve before each use following the instructions

found in Checking the Safety Valve.

Inspect the tank yearly for rust, pin holes, or other

imperfections that could cause it to become unsafe.

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use.

Use clean cloths to remove dirt, dust, oil, grease, etc.

LUBRICATION

All the bearings in this tool are lubricated with a sufficient

amount of high grade lubricant for the life of the unit

under normal operating conditions. Therefore, no further

lubrication of the bearings is required.

WARNING:

Do not at any time let brake ﬂ uids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact

with plastic parts. Chemical can damage, weaken or

destroy plastic which may result in serious personal

injury. Electric tools used on ﬁ berglass material, wall-

board, spackling compounds, or plaster are subject

to accelerated wear and possible premature failure

because the ﬁ berglass chips and grindings are highly

abrasive to bearings, brushes, commutators, etc.

Consequently, we do not recommend using this tool for

extended work on these type of materials. However, if

you do work with any of these materials, it is extremely

important to clean the tool using compressed air.

OPERATION

HOSE STORAGE STRAP

See Figure 10.

This compressor features an accessory storage strap for

storage of air hose up to 25’ in length. To secure hose

with storage strap, overlap the hook and loop pads on the

end of each strap by at least 3 inches and press together

firmly.

Fig. 10

HOSE STORAGE

STRAP

HOOK AND LOOP PADS

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Fini AB1PAK Manuel d'utilisation et d'entretien Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Compresseurs d'air Fini AB1PAK